Shipco Duplex DUCD condensate return basin packages each consisting of: 36" x 36" x 3/16" thickness 158 gallon 304L stainless steel with painted finish note: IDE's in a condensate system will destroy stainless steel. No warranty on receiver if present 40" steel cover plate 1/4" thickness includes: 4" inlet & 2" discharge 70 gpm @ 15 psi discharge (35' tdh) (2) 113-U column type 3HP 3500 RPM 460/3/60 volt premium efficiency 182JM TEFC motors mounted bronze ball cone check valves pump suction strainers mounted on pumps pump column will be carbon steel Shipco mounted and wired NEMA 1 UL control panel consisting of: liquid tight conduit integral magnetic starters & integral circuit breakers 115 volt fused control, transformer control circuit disconnect numbered terminal removable mounting plate alarm bell auto-off-continuous w/ test button single point power Aqueous controller PLC with level and temperature transmitters 24 volt -control enclosure NEMA 4X panel short circuit rating of 5000Amps Standard on Aqueous PID loop controller control circuit disconnect switch and alarm bell with light auto on-off-continuous switch for each pump high high, high, low, low low and signal loss alarms for level temperature and pressure with alarm log pump cut-off for low level, high temperature and high pressure idle/ run/ fault/ pump status and pump run status along with pump run timers for cycle and total BACnet & Modbus over serial and Ethernet remote over-rides for BAS, SCADA, DDC, etc. Power into this panel is 115/1/60 volt HMI touch screen 4" Estimated production time is 18 weeks (subject to change)